Physical Damage Recovery Techniques


  • assume that unless the case is visibly damaged, the drive itself is still operable
  • when presented with “failed hard drive” use the following techniques to retrieve data:
    1. remove the drive from the system
      • connect to a test system
      • don’t install the drive, only connect data and power cables
    2. boot test system from own internal drive
      • listen to the failed drive to determine whether the internal disks are spinning
      • if yes, then can likely recover data
    3. determine whether failed drive is recognized and can be installed on the test system
      • if drive installs, copy all directories and files to a hard drive on the test system
      • if drive fails on one system but installs on another, the drive may be usable
      • may have failed due to
        • power supply failure
        • OS corruption
        • malware
        • etc
      • run a virus check on recovered data and test for integrity
    4. if hard drive is not spinning or test system does not recognize it, perform limited repair
      • use specialized software to image all data bits to a recovery drive
      • use extracted raw image to reconstruct usable data
      • use DCFLdd for this
    5. if necessary, send device to data recovery specialists
  • if data is deemed lost, you can try:
    1. remove the printed circuit board and replace it with a matching circuit board from a known healthy drive
    2. change the read/write head assembly with known good part
    3. remove hard disk platters from original drive and install them into a known healthy drive