Hardware Knowledge Requirements for Computer Forensics Analysis
Hardware
Random Access Memory
- sequentially from older to newer technologies:
- Extended data out dynamic random access memory (EDO DRAM)
- single-cycle EDO has the ability to carry out a complete memory transaction in one clock cycle
- otherwise, each sequential RAM access within the same page takes two clock cycles instead of three, once the page has been selected
- Burst EDO (BEDO) DRAM
- An evolution of the EDO, burst EDO DRAM can process four memory addresses in one burst
- Asynchronous dynamic random access memory (ADRAM)
- is not synchronized to the CPU clock
- Synchronous dynamic random access memory (SDRAM)
- Double data rate (DDR) SDRAM
- was a later development of SDRAM
- another way to look at RAM is the level of volatility:
- Random access memory
- is very volatile
- data is gone when power is discontinued
- Read-only memory (ROM)
- not volatile
- cannot be changed
- used for instructions embedded in chips
- controls how the computer, option cards, peripherals, and other devices operate
- Programmable read-only memory (PRAM)
- can be programmed only once
- data is not lost when power is removed
- Erasable programmable read-only memory (EPRAM)
- data is not lost when power is removed
- is a technique for storing instructions on chips
- Electronically erasable programmable read-only memory (EEPRAM)
- this form is how the instructions in your computer’s basing input/output system (BIOS) are stored
Hard Drives
- connectors:
- small computer system interface (SCSI)
- common in high-end servers
- SCSI devices must have a terminator at the end of the chain of devices to work
- limited to 16 chained devices
- Integrated Drive Electronics (IDE)
- old standard
- uses a 40 pin connector
- Enhanced IDE (EIDE)
- Parallel advanced technology attachment (PATA)
- Serial Advanced Technology Attachment (SATA)
- Serial SCSI
- Solid-state drive (SSD)