Fiber to the Curb (FTTC) & Fiber to the Premises (FTTP)


  • The major obstacle to providing internet access that can perform like a LAN is bandwidth in the last mile
    • the copper wiring infrastructure is often low-grade
    • projects to update this wiring to use fiber optic links are referred to by the umbrella term fiber to the X (FTTx)

Fiber to the Curb and VDSL

A fiber to the curb (FTTC) solution retains some sort of copper wiring to the customer premises while extending the fiber link from the point of presence to a communications cabinet servicing multiple subscribers.

  • service providers with their roots in telephone networks use very high-speed DSL (VDSL) to support FTTC
    • achieves higher bit rates than other DSL types at the expense of range
    • supports two modes:
      • symmetric
        • 52 Mbps downstream
        • 6 Mbps upstream
        • 300 m (1,000 ft)
      • asymmetric
        • 26 Mbps in both directions
    • VDSL2
      • specifies a very short range (100 m/300 feet) rate of 100 Mbps (bidirectional)

Info

  • Modem type must match the service
    • ADSL-only modem cannot use for VDSL service

Fiber to the Premises and Optical Network Terminals

A fiber to the premises (FTTP) Internet connection means that the service provider’s fiber optic cable is run all the way to the customer’s building.

  • This full fiber connection type is implemented as a passive optical network (PON)
    • a single fiber cable is run from the point of presence to an optical line terminal (OLT)
      • located in a street cabinet
    • From OLT, splitters direct each subscriber’s traffic over a shorter length of fiber to an optical network terminal (ONT)
      • installed at customer’s premises
      • converts the optical signal to an electrical one
      • is connected to the customer’s router using an RJ45 copper wire patch cord